P00E8 — Intake air temp sensor 3 bank 1: circuit fault
| Meaning | The engine computer detected a general electrical problem in the circuit of intake air temperature sensor 3, bank 1. Bank 1 is the side of the engine with cylinder 1. Where sensor 3 sits physically is decided by the manufacturer and I can't state it in general. |
| Family | Powertrain (P) |
Typical symptoms
Slight drop in performance
Rough idle
Cold starts less crisp
No obvious symptoms in some cases
Common causes
Damaged or broken wiring
Faulty sensor
Unstable sensor supply or ground
Faulty engine computer (rare)
What to do
How to read code P00E8
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P00E8 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (0) points to fuel and air metering and auxiliary emission controls, and the last two (E8) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P00E8 mean?
Intake air temp sensor 3 bank 1: circuit fault. The engine computer detected a general electrical problem in the circuit of intake air temperature sensor 3, bank 1. Bank 1 is the side of the engine with cylinder 1. Where sensor 3 sits physically is decided by the manufacturer and I can't state it in general.
Can I keep driving with code P00E8 active?
With caution: limp mode possible, have it checked soon
Common causes — P00E8
Corroded or loose sensor connector Damaged or broken wiring Faulty sensor Unstable sensor supply or ground Faulty engine computer (rare)
How do you fix code P00E8?
First locate the sensor on your model and check the connector and wires for moisture, chafing or bent terminals. Then a technician can measure signal and resistance. It is not an emergency, but don't delay too long.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P00E7 — Intake air temperature bank 2: sensors disagree
- Next code: P00E9 — Intake air temp sensor 3 bank 1: reading not plaus...
Related codes
- P0001 — Fuel Volume Regulator Control Circuit Open
- P0002 — Fuel volume regulator performance out of range
- P0003 — Fuel volume regulator control circuit low
- P0004 — Fuel volume regulator control circuit high
- P0005 — Fuel shutoff valve control circuit fault
- P0006 — Fuel shutoff valve control circuit low
- P0007 — Fuel shutoff valve control circuit high
- P0008 — Engine position system performance, bank 1
- P0009 — Engine position system performance, bank 2
- P000A — Camshaft A position slow response, bank 1
- P000B — Camshaft B position slow response, bank 1
- P000C — Camshaft A position slow response, bank 2