P00F2 — Humidity sensor circuit open or faulty
| Meaning | The engine computer detected an electrical problem in the humidity sensor circuit, typically a broken wire or a sensor that does not respond. The sensor measures the humidity of the intake air and the computer uses it to adjust engine management. Without this data it works with fallback values. |
| Family | Powertrain (P) |
Typical symptoms
Slight drop in performance
Slightly rough idle
Less crisp starting in damp weather
No obvious symptoms in some cases
Common causes
Broken or damaged wire
Faulty humidity sensor
Missing sensor supply or ground
Faulty engine computer (rare)
What to do
How to read code P00F2
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P00F2 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (0) points to fuel and air metering and auxiliary emission controls, and the last two (F2) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P00F2 mean?
Humidity sensor circuit open or faulty. The engine computer detected an electrical problem in the humidity sensor circuit, typically a broken wire or a sensor that does not respond. The sensor measures the humidity of the intake air and the computer uses it to adjust engine management. Without this data it works with fallback values.
Can I keep driving with code P00F2 active?
With caution: limp mode possible, have it checked soon
Common causes — P00F2
Connector unplugged, corroded or wet Broken or damaged wire Faulty humidity sensor Missing sensor supply or ground Faulty engine computer (rare)
How do you fix code P00F2?
First check the sensor connector and wires for moisture, corrosion or cuts. Then supply and signal are measured with a scan tool or multimeter. It is not an emergency, but have it checked soon.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P00F1 — Intake air temp sensor 3 bank 2: erratic signal
- Next code: P00F3 — Humidity sensor out of range or not plausible
Related codes
- P0001 — Fuel Volume Regulator Control Circuit Open
- P0002 — Fuel volume regulator performance out of range
- P0003 — Fuel volume regulator control circuit low
- P0004 — Fuel volume regulator control circuit high
- P0005 — Fuel shutoff valve control circuit fault
- P0006 — Fuel shutoff valve control circuit low
- P0007 — Fuel shutoff valve control circuit high
- P0008 — Engine position system performance, bank 1
- P0009 — Engine position system performance, bank 2
- P000A — Camshaft A position slow response, bank 1
- P000B — Camshaft B position slow response, bank 1
- P000C — Camshaft A position slow response, bank 2