P00F6 — Humidity sensor circuit: erratic or intermittent signal
| Meaning | The engine computer sees the intake air humidity sensor signal appear and disappear, or change in a way that does not make sense. This usually points to an electrical contact that comes and goes, or a sensor that is starting to fail. |
| Family | Powertrain (P) |
Typical symptoms
Occasional wandering idle
Small hesitations when accelerating
Problem shows up in rain, damp weather or with vibration
No obvious symptom, just the warning light
Common causes
Pinched or chafed wire touching at times
Humidity sensor starting to fail
Water or condensation in the connector
Engine computer fault (rare)
What to do
How to read code P00F6
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P00F6 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (0) points to fuel and air metering and auxiliary emission controls, and the last two (F6) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P00F6 mean?
Humidity sensor circuit: erratic or intermittent signal. The engine computer sees the intake air humidity sensor signal appear and disappear, or change in a way that does not make sense. This usually points to an electrical contact that comes and goes, or a sensor that is starting to fail.
Can I keep driving with code P00F6 active?
With caution: limp mode possible, have it checked soon
Common causes — P00F6
Connector with intermittent contact Pinched or chafed wire touching at times Humidity sensor starting to fail Water or condensation in the connector Engine computer fault (rare)
How do you fix code P00F6?
Check the connector and wiring by gently moving them with the engine running while a technician watches the live reading. Intermittent faults are hard to find, so have it checked before it becomes a permanent fault.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P00F5 — Humidity sensor circuit: signal too high
- Next code: P00F7 — Barometric and turbo inlet pressure mismatch (bank...
Related codes
- P0001 — Fuel Volume Regulator Control Circuit Open
- P0002 — Fuel volume regulator performance out of range
- P0003 — Fuel volume regulator control circuit low
- P0004 — Fuel volume regulator control circuit high
- P0005 — Fuel shutoff valve control circuit fault
- P0006 — Fuel shutoff valve control circuit low
- P0007 — Fuel shutoff valve control circuit high
- P0008 — Engine position system performance, bank 1
- P0009 — Engine position system performance, bank 2
- P000A — Camshaft A position slow response, bank 1
- P000B — Camshaft B position slow response, bank 1
- P000C — Camshaft A position slow response, bank 2