P00F5 — Humidity sensor circuit: signal too high
| Meaning | The engine computer detected a higher than normal voltage on the intake air humidity sensor circuit. The reading is not considered believable, so the computer may ignore the sensor and run on preset values. |
| Family | Powertrain (P) |
Typical symptoms
Unstable idle in some conditions
Less even power delivery
Fuel use slightly different from usual
No obvious symptom, just the warning light
Common causes
Corroded connector or loose terminals
Short to the power supply
Faulty humidity sensor
Engine computer fault (rare)
What to do
How to read code P00F5
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P00F5 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (0) points to fuel and air metering and auxiliary emission controls, and the last two (F5) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P00F5 mean?
Humidity sensor circuit: signal too high. The engine computer detected a higher than normal voltage on the intake air humidity sensor circuit. The reading is not considered believable, so the computer may ignore the sensor and run on preset values.
Can I keep driving with code P00F5 active?
With caution: limp mode possible, have it checked soon
Common causes — P00F5
Broken sensor wire or poor contact Corroded connector or loose terminals Short to the power supply Faulty humidity sensor Engine computer fault (rare)
How do you fix code P00F5?
Start with the connector and wiring of the sensor, then check its supply and ground with the right tool. It is usually not an emergency, but do not put the diagnosis off for too long.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P00F4 — Humidity sensor circuit: signal too low
- Next code: P00F6 — Humidity sensor circuit: erratic or intermittent s...
Related codes
- P0001 — Fuel Volume Regulator Control Circuit Open
- P0002 — Fuel volume regulator performance out of range
- P0003 — Fuel volume regulator control circuit low
- P0004 — Fuel volume regulator control circuit high
- P0005 — Fuel shutoff valve control circuit fault
- P0006 — Fuel shutoff valve control circuit low
- P0007 — Fuel shutoff valve control circuit high
- P0008 — Engine position system performance, bank 1
- P0009 — Engine position system performance, bank 2
- P000A — Camshaft A position slow response, bank 1
- P000B — Camshaft B position slow response, bank 1
- P000C — Camshaft A position slow response, bank 2