P00F8 — Turbo outlet pressure sensor A: circuit fault
| Meaning | The engine computer detected a general electrical problem in the circuit of sensor A, which measures air pressure at the turbocharger outlet. Without this reading it cannot control boost pressure properly. |
| Family | Powertrain (P) |
Typical symptoms
Loss of power
Turbo seems not to push, or pushes in surges
Engine in reduced power mode
Exhaust smoke when accelerating
Common causes
Broken, disconnected or shorted wires
Faulty pressure sensor
Sensor fouled with oil or soot
Engine computer fault (rare)
What to do
How to read code P00F8
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P00F8 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (0) points to fuel and air metering and auxiliary emission controls, and the last two (F8) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P00F8 mean?
Turbo outlet pressure sensor A: circuit fault. The engine computer detected a general electrical problem in the circuit of sensor A, which measures air pressure at the turbocharger outlet. Without this reading it cannot control boost pressure properly.
Can I keep driving with code P00F8 active?
With caution: limp mode possible, have it checked soon
Common causes — P00F8
Corroded or poorly seated sensor connector Broken, disconnected or shorted wires Faulty pressure sensor Sensor fouled with oil or soot Engine computer fault (rare)
How do you fix code P00F8?
Inspect the sensor, its connector and wiring, then have the readings checked with a diagnostic tool. If the car goes into reduced power, use it as little as possible until it is checked.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P00F7 — Barometric and turbo inlet pressure mismatch (bank...
- Next code: P00F9 — Turbo outlet pressure sensor A: implausible readin...
Related codes
- P0001 — Fuel Volume Regulator Control Circuit Open
- P0002 — Fuel volume regulator performance out of range
- P0003 — Fuel volume regulator control circuit low
- P0004 — Fuel volume regulator control circuit high
- P0005 — Fuel shutoff valve control circuit fault
- P0006 — Fuel shutoff valve control circuit low
- P0007 — Fuel shutoff valve control circuit high
- P0008 — Engine position system performance, bank 1
- P0009 — Engine position system performance, bank 2
- P000A — Camshaft A position slow response, bank 1
- P000B — Camshaft B position slow response, bank 1
- P000C — Camshaft A position slow response, bank 2