Skip to content
Fault code dictionary (DTC)

P00FB — Turbo outlet pressure sensor A: signal too high

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe engine computer read too high a voltage from sensor A at the turbo outlet. It may come from an electrical fault in the sensor, or from boost pressure that really is too high.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Power limited by the computer
Surging boost
Exhaust smoke
Unusual noises from the turbo

Common causes

Sensor wire broken or shorted to the power supply
Connector with poor contact
Faulty pressure sensor
Stuck or faulty turbo control
Blocked exhaust or ducts raising pressure

What to do

Inspect the wiring and connector, then have the real pressure checked with a tool. A true overpressure can damage the engine, so do not put it off.

How to read code P00FB

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P00FB starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (0) points to fuel and air metering and auxiliary emission controls, and the last two (FB) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P00FB mean?

Turbo outlet pressure sensor A: signal too high. The engine computer read too high a voltage from sensor A at the turbo outlet. It may come from an electrical fault in the sensor, or from boost pressure that really is too high.

Can I keep driving with code P00FB active?

With caution: limp mode possible, have it checked soon

Common causes — P00FB

Sensor wire broken or shorted to the power supply Connector with poor contact Faulty pressure sensor Stuck or faulty turbo control Blocked exhaust or ducts raising pressure

How do you fix code P00FB?

Inspect the wiring and connector, then have the real pressure checked with a tool. A true overpressure can damage the engine, so do not put it off.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes