Skip to content
Fault code dictionary (DTC)

P00FA — Turbo outlet pressure sensor A: signal too low

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe engine computer read too low a voltage from sensor A, which measures pressure at the turbo outlet. It may be an electrical fault, or the pressure may really be lower than planned.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Lack of power
Turbo seems not to act
Engine in reduced power mode
Sluggish acceleration

Common causes

Sensor wire shorted to ground
Damaged or wet connector
Faulty pressure sensor
Major air leak in the boost circuit
Turbocharger not building pressure

What to do

Check the connector, wiring and any visible air leaks. If the loss of power is marked, limit use of the car and have it diagnosed soon.

How to read code P00FA

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P00FA starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (0) points to fuel and air metering and auxiliary emission controls, and the last two (FA) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P00FA mean?

Turbo outlet pressure sensor A: signal too low. The engine computer read too low a voltage from sensor A, which measures pressure at the turbo outlet. It may be an electrical fault, or the pressure may really be lower than planned.

Can I keep driving with code P00FA active?

With caution: limp mode possible, have it checked soon

Common causes — P00FA

Sensor wire shorted to ground Damaged or wet connector Faulty pressure sensor Major air leak in the boost circuit Turbocharger not building pressure

How do you fix code P00FA?

Check the connector, wiring and any visible air leaks. If the loss of power is marked, limit use of the car and have it diagnosed soon.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes