Skip to content
Fault code dictionary (DTC)

P012D — Turbo/supercharger inlet pressure sensor A signal too high

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit reads a higher than normal voltage on the circuit of pressure sensor A at the turbo or supercharger inlet. It is often caused by a wire shorted to the supply, a missing ground, or a faulty sensor.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Loss of power or an engine that pulls weakly
Possible reduced power mode
Uneven throttle response
Higher than normal fuel use

Common causes

Signal wire shorted to supply voltage
Sensor ground broken or making poor contact
Failed pressure sensor
Damaged connector or moisture in it
Pressure genuinely too high because of a boost problem

What to do

Check the sensor ground, wiring and connector, looking for moisture or corrosion. If the circuit is fine, have the real pressure checked. Avoid pushing the throttle hard until it has been checked.

How to read code P012D

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P012D starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (2D) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P012D mean?

Turbo/supercharger inlet pressure sensor A signal too high. The control unit reads a higher than normal voltage on the circuit of pressure sensor A at the turbo or supercharger inlet. It is often caused by a wire shorted to the supply, a missing ground, or a faulty sensor.

Can I keep driving with code P012D active?

With caution: limp mode possible, have it checked soon

Common causes — P012D

Signal wire shorted to supply voltage Sensor ground broken or making poor contact Failed pressure sensor Damaged connector or moisture in it Pressure genuinely too high because of a boost problem

How do you fix code P012D?

Check the sensor ground, wiring and connector, looking for moisture or corrosion. If the circuit is fine, have the real pressure checked. Avoid pushing the throttle hard until it has been checked.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes