P012E — Turbo/supercharger inlet pressure sensor A signal intermittent
| Meaning | The control unit sees the signal from pressure sensor A at the turbo or supercharger inlet appear and disappear, or vary in an abnormal way. The fault comes and goes, which is why it is often linked to poor contacts or damaged wires. |
| Family | Powertrain (P) |
Typical symptoms
Sudden, irregular power drops
Jerking or hesitation when accelerating
Idle that hunts up and down
Reduced power mode from time to time
Common causes
Chafed wire that makes contact only at times
Pressure sensor failing intermittently
Vibration or moisture on the wiring
Intermittent ground or supply problem
What to do
How to read code P012E
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P012E starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (2E) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P012E mean?
Turbo/supercharger inlet pressure sensor A signal intermittent. The control unit sees the signal from pressure sensor A at the turbo or supercharger inlet appear and disappear, or vary in an abnormal way. The fault comes and goes, which is why it is often linked to poor contacts or damaged wires.
Can I keep driving with code P012E active?
With caution: limp mode possible, have it checked soon
Common causes — P012E
Loose connector or corroded contacts Chafed wire that makes contact only at times Pressure sensor failing intermittently Vibration or moisture on the wiring Intermittent ground or supply problem
How do you fix code P012E?
With the engine running, gently move the wiring and connector to see whether the fault shows up, and check the contacts. An intermittent fault tends to get worse, so it is not wise to put the check off for long.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P012D — Turbo/supercharger inlet pressure sensor A signal...
- Next code: P012F — Engine coolant and engine oil temperature do not a...
Related codes
- P0100 — Mass air flow sensor: general circuit fault
- P0101 — Mass air flow sensor: range/performance
- P0102 — Mass air flow sensor: signal too low
- P0103 — Mass air flow sensor: signal too high
- P0104 — Mass air flow sensor: intermittent signal
- P0105 — Manifold/barometric pressure sensor: general circuit fault
- P0106 — Manifold/barometric pressure sensor: implausible reading
- P0107 — Manifold/barometric pressure sensor: signal too low
- P0108 — Manifold/barometric pressure sensor: signal too high
- P0109 — Manifold/barometric pressure sensor: intermittent signal
- P010A — Mass air flow sensor B: circuit fault
- P010B — Air flow sensor B: signal out of range or implausible