P012F — Engine coolant and engine oil temperature do not agree
| Meaning | The control unit compares coolant temperature with engine oil temperature and finds that the two values do not agree after a certain running time. It may be a sensor reading wrongly, or a genuine thermal problem in the engine. |
| Family | Powertrain (P) |
Typical symptoms
Temperature gauge behaving oddly
Cooling fan starting at unusual moments
Uneven cabin heating
No obvious symptoms in some cases
Common causes
Thermostat not working properly
Damaged wiring or connector on one of the sensors
Abnormal coolant level or circulation
Problem in the cooling circuit or oil cooler
What to do
How to read code P012F
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P012F starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (2F) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P012F mean?
Engine coolant and engine oil temperature do not agree. The control unit compares coolant temperature with engine oil temperature and finds that the two values do not agree after a certain running time. It may be a sensor reading wrongly, or a genuine thermal problem in the engine.
Can I keep driving with code P012F active?
With caution: limp mode possible, have it checked soon
Common causes — P012F
Faulty coolant or oil temperature sensor Thermostat not working properly Damaged wiring or connector on one of the sensors Abnormal coolant level or circulation Problem in the cooling circuit or oil cooler
How do you fix code P012F?
Check coolant and oil levels with the engine cold, then have both values compared with a scan tool from cold and when warm. If the real temperature seems high, stop and do not push the engine.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P012E — Turbo/supercharger inlet pressure sensor A signal...
- Next code: P0130 — Oxygen Sensor Circuit Malfunction - Bank 1 Sensor...
Related codes
- P0100 — Mass air flow sensor: general circuit fault
- P0101 — Mass air flow sensor: range/performance
- P0102 — Mass air flow sensor: signal too low
- P0103 — Mass air flow sensor: signal too high
- P0104 — Mass air flow sensor: intermittent signal
- P0105 — Manifold/barometric pressure sensor: general circuit fault
- P0106 — Manifold/barometric pressure sensor: implausible reading
- P0107 — Manifold/barometric pressure sensor: signal too low
- P0108 — Manifold/barometric pressure sensor: signal too high
- P0109 — Manifold/barometric pressure sensor: intermittent signal
- P010A — Mass air flow sensor B: circuit fault
- P010B — Air flow sensor B: signal out of range or implausible