P013D — Downstream O2 sensor bank 2: slow response, lean to rich
| Meaning | The oxygen sensor after the catalytic converter on bank 2 reacts too slowly when the mixture changes from lean to rich. Bank 2 is the row of cylinders opposite the one that holds cylinder 1, found on V-type or flat engines. |
| Family | Powertrain (P) |
Typical symptoms
Usually no obvious change
Worse emissions
Slightly altered fuel use
Possible failed emissions inspection
Common causes
Exhaust leak near the sensor
Damaged wiring or connector
Bank 2 catalytic converter with reduced efficiency
Weak sensor heater
What to do
How to read code P013D
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P013D starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (3D) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P013D mean?
Downstream O2 sensor bank 2: slow response, lean to rich. The oxygen sensor after the catalytic converter on bank 2 reacts too slowly when the mixture changes from lean to rich. Bank 2 is the row of cylinders opposite the one that holds cylinder 1, found on V-type or flat engines.
Can I keep driving with code P013D active?
With caution: limp mode possible, have it checked soon
Common causes — P013D
Aged or contaminated bank 2 downstream sensor Exhaust leak near the sensor Damaged wiring or connector Bank 2 catalytic converter with reduced efficiency Weak sensor heater
How do you fix code P013D?
Make sure you are looking at the sensor on the correct bank, then check for exhaust leaks, wiring and connector. Have the sensor tested with a scan tool. It is not urgent, but it is best to act in good time.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P013C — Downstream O2 sensor bank 2: slow response, rich t...
- Next code: P013E — Downstream O2 sensor bank 1: delayed response, ric...
Related codes
- P0100 — Mass air flow sensor: general circuit fault
- P0101 — Mass air flow sensor: range/performance
- P0102 — Mass air flow sensor: signal too low
- P0103 — Mass air flow sensor: signal too high
- P0104 — Mass air flow sensor: intermittent signal
- P0105 — Manifold/barometric pressure sensor: general circuit fault
- P0106 — Manifold/barometric pressure sensor: implausible reading
- P0107 — Manifold/barometric pressure sensor: signal too low
- P0108 — Manifold/barometric pressure sensor: signal too high
- P0109 — Manifold/barometric pressure sensor: intermittent signal
- P010A — Mass air flow sensor B: circuit fault
- P010B — Air flow sensor B: signal out of range or implausible