Skip to content
Fault code dictionary (DTC)

P013E — Downstream O2 sensor bank 1: delayed response, rich to lean

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe oxygen sensor after the catalytic converter on bank 1 takes too long to register the change from a rich to a lean mixture. The delay is different from a simply slow signal: the sensor starts to react later than the control unit expects.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Usually no obvious change
Worse emissions
Slightly altered fuel use
Possible failed emissions inspection

Common causes

Aged or contaminated downstream sensor
Exhaust leak near the sensor
Damaged wiring or connector
Catalytic converter with reduced efficiency
Weak sensor heater

What to do

First check for exhaust leaks and the sensor wiring and connector. Then have the signal checked with a scan tool. It is not an emergency, but do not neglect it for long.

How to read code P013E

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P013E starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (3E) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P013E mean?

Downstream O2 sensor bank 1: delayed response, rich to lean. The oxygen sensor after the catalytic converter on bank 1 takes too long to register the change from a rich to a lean mixture. The delay is different from a simply slow signal: the sensor starts to react later than the control unit expects.

Can I keep driving with code P013E active?

With caution: limp mode possible, have it checked soon

Common causes — P013E

Aged or contaminated downstream sensor Exhaust leak near the sensor Damaged wiring or connector Catalytic converter with reduced efficiency Weak sensor heater

How do you fix code P013E?

First check for exhaust leaks and the sensor wiring and connector. Then have the signal checked with a scan tool. It is not an emergency, but do not neglect it for long.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes