P0182 — Fuel temperature sensor A: signal too low
| Meaning | The control unit found a lower than normal voltage on the circuit of fuel temperature sensor A. This can come from a short to ground or from a faulty sensor. The unit can no longer know for sure how hot the fuel is and uses a substitute value. |
| Family | Powertrain (P) |
Typical symptoms
Starting slower than usual, cold or hot
Fuel consumption that seems higher
Rough running or weak acceleration
Smoke from the exhaust on some diesel engines
Common causes
Pinched or worn wire touching ground
Faulty fuel temperature sensor
Internal control unit fault, which is rare
What to do
How to read code P0182
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0182 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (82) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0182 mean?
Fuel temperature sensor A: signal too low. The control unit found a lower than normal voltage on the circuit of fuel temperature sensor A. This can come from a short to ground or from a faulty sensor. The unit can no longer know for sure how hot the fuel is and uses a substitute value.
Can I keep driving with code P0182 active?
With caution: limp mode possible, have it checked soon
Common causes — P0182
Corroded or water-filled sensor connector Pinched or worn wire touching ground Faulty fuel temperature sensor Internal control unit fault, which is rare
How do you fix code P0182?
First check the sensor connector and wiring for moisture, corrosion or damaged insulation. You can drive for a short time, but have it checked soon because fuel management is working on substitute data.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0181 — Fuel temperature sensor A: performance problem
- Next code: P0183 — Fuel temperature sensor A: signal too high
Related codes
- P0100 — Mass air flow sensor: general circuit fault
- P0101 — Mass air flow sensor: range/performance
- P0102 — Mass air flow sensor: signal too low
- P0103 — Mass air flow sensor: signal too high
- P0104 — Mass air flow sensor: intermittent signal
- P0105 — Manifold/barometric pressure sensor: general circuit fault
- P0106 — Manifold/barometric pressure sensor: implausible reading
- P0107 — Manifold/barometric pressure sensor: signal too low
- P0108 — Manifold/barometric pressure sensor: signal too high
- P0109 — Manifold/barometric pressure sensor: intermittent signal
- P010A — Mass air flow sensor B: circuit fault
- P010B — Air flow sensor B: signal out of range or implausible