P0183 — Fuel temperature sensor A: signal too high
| Meaning | The control unit found a higher than normal voltage on the circuit of fuel temperature sensor A. This usually means a broken wire, an unplugged connector or a faulty sensor. The unit reads an implausible temperature and falls back on a substitute value. |
| Family | Powertrain (P) |
Typical symptoms
Hard starting, especially when cold
Rough idle
Loss of power or weak acceleration
Higher than usual fuel consumption
Common causes
Broken wire in the harness
Faulty fuel temperature sensor
Interrupted supply or ground to the sensor
Internal control unit fault, which is rare
What to do
How to read code P0183
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0183 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (83) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0183 mean?
Fuel temperature sensor A: signal too high. The control unit found a higher than normal voltage on the circuit of fuel temperature sensor A. This usually means a broken wire, an unplugged connector or a faulty sensor. The unit reads an implausible temperature and falls back on a substitute value.
Can I keep driving with code P0183 active?
With caution: limp mode possible, have it checked soon
Common causes — P0183
Unplugged connector or loose terminals at the sensor Broken wire in the harness Faulty fuel temperature sensor Interrupted supply or ground to the sensor Internal control unit fault, which is rare
How do you fix code P0183?
First make sure the connector is fully seated and the wires are not broken, especially near vibration points. You can drive carefully for a short time, but have the circuit checked as soon as possible.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0182 — Fuel temperature sensor A: signal too low
- Next code: P0184 — Fuel temperature sensor A: intermittent signal
Related codes
- P0100 — Mass air flow sensor: general circuit fault
- P0101 — Mass air flow sensor: range/performance
- P0102 — Mass air flow sensor: signal too low
- P0103 — Mass air flow sensor: signal too high
- P0104 — Mass air flow sensor: intermittent signal
- P0105 — Manifold/barometric pressure sensor: general circuit fault
- P0106 — Manifold/barometric pressure sensor: implausible reading
- P0107 — Manifold/barometric pressure sensor: signal too low
- P0108 — Manifold/barometric pressure sensor: signal too high
- P0109 — Manifold/barometric pressure sensor: intermittent signal
- P010A — Mass air flow sensor B: circuit fault
- P010B — Air flow sensor B: signal out of range or implausible