P0184 — Fuel temperature sensor A: intermittent signal
| Meaning | The control unit saw the signal from fuel temperature sensor A drop out or change erratically. This often comes from an electrical contact that works only part of the time. The fault may therefore show up only in certain conditions, such as vibration or moisture. |
| Family | Powertrain (P) |
Typical symptoms
Starting sometimes hard and sometimes normal
Occasional rough running
Occasional drops in power
Common causes
Partly broken wire making contact on and off
Fuel temperature sensor failing intermittently
Moisture in the connector or harness
What to do
How to read code P0184
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0184 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (84) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0184 mean?
Fuel temperature sensor A: intermittent signal. The control unit saw the signal from fuel temperature sensor A drop out or change erratically. This often comes from an electrical contact that works only part of the time. The fault may therefore show up only in certain conditions, such as vibration or moisture.
Can I keep driving with code P0184 active?
With caution: limp mode possible, have it checked soon
Common causes — P0184
Connector with corroded or loose contacts Partly broken wire making contact on and off Fuel temperature sensor failing intermittently Moisture in the connector or harness
How do you fix code P0184?
With the engine off, gently move the sensor connector and wiring and look for corrosion, moisture or damaged wires. Since the problem comes and goes, don't put the check off, because it can get worse and become permanent.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0183 — Fuel temperature sensor A: signal too high
- Next code: P0185 — Fuel temperature sensor B: circuit fault
Related codes
- P0100 — Mass air flow sensor: general circuit fault
- P0101 — Mass air flow sensor: range/performance
- P0102 — Mass air flow sensor: signal too low
- P0103 — Mass air flow sensor: signal too high
- P0104 — Mass air flow sensor: intermittent signal
- P0105 — Manifold/barometric pressure sensor: general circuit fault
- P0106 — Manifold/barometric pressure sensor: implausible reading
- P0107 — Manifold/barometric pressure sensor: signal too low
- P0108 — Manifold/barometric pressure sensor: signal too high
- P0109 — Manifold/barometric pressure sensor: intermittent signal
- P010A — Mass air flow sensor B: circuit fault
- P010B — Air flow sensor B: signal out of range or implausible