Skip to content
Fault code dictionary (DTC)

P019C — O2 sensor 3 bank 2: slow response, rich to lean

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit has found that the third oxygen sensor on bank 2 reacts too slowly when the mixture swings from rich to lean. Bank 2 is the side of a V or flat engine that does not contain cylinder 1. The sensor's data can no longer be trusted.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Usually no obvious change in driving
Possibly a slightly uneven idle in some cases
Failing an emissions inspection
Exhaust self-checks not being completed

Common causes

Aged or contaminated oxygen sensor
Exhaust leak near the sensor
Damaged or corroded wiring or connector
Weak internal heater in the sensor
Contamination from oil, coolant or fuel additives
Catalytic converter or exhaust problem, less common

What to do

First make sure you are looking at the correct bank, then check for exhaust leaks and inspect the wiring and connector. The car can usually still be driven, but have the light checked within a reasonable time. Swapping sensors between the two banks can help show whether the fault follows the sensor or stays with the bank.

How to read code P019C

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P019C starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (9C) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P019C mean?

O2 sensor 3 bank 2: slow response, rich to lean. The control unit has found that the third oxygen sensor on bank 2 reacts too slowly when the mixture swings from rich to lean. Bank 2 is the side of a V or flat engine that does not contain cylinder 1. The sensor's data can no longer be trusted.

Can I keep driving with code P019C active?

With caution: limp mode possible, have it checked soon

Common causes — P019C

Aged or contaminated oxygen sensor Exhaust leak near the sensor Damaged or corroded wiring or connector Weak internal heater in the sensor Contamination from oil, coolant or fuel additives Catalytic converter or exhaust problem, less common

How do you fix code P019C?

First make sure you are looking at the correct bank, then check for exhaust leaks and inspect the wiring and connector. The car can usually still be driven, but have the light checked within a reasonable time. Swapping sensors between the two banks can help show whether the fault follows the sensor or stays with the bank.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes