P019D — O2 sensor 3 bank 2: slow response, lean to rich
| Meaning | The control unit has found that the third oxygen sensor on bank 2 reacts too slowly when the mixture swings from lean to rich. Bank 2 is the side of a V or flat engine that does not contain cylinder 1. The sensor's data can no longer be trusted. |
| Family | Powertrain (P) |
Typical symptoms
Usually no obvious change in driving
Possibly a slightly uneven idle in some cases
Failing an emissions inspection
Exhaust self-checks not being completed
Common causes
Exhaust leak near the sensor
Damaged or corroded wiring or connector
Weak internal heater in the sensor
Contamination from oil, coolant or fuel additives
Catalytic converter or exhaust problem, less common
What to do
How to read code P019D
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P019D starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (9D) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P019D mean?
O2 sensor 3 bank 2: slow response, lean to rich. The control unit has found that the third oxygen sensor on bank 2 reacts too slowly when the mixture swings from lean to rich. Bank 2 is the side of a V or flat engine that does not contain cylinder 1. The sensor's data can no longer be trusted.
Can I keep driving with code P019D active?
With caution: limp mode possible, have it checked soon
Common causes — P019D
Aged or contaminated oxygen sensor Exhaust leak near the sensor Damaged or corroded wiring or connector Weak internal heater in the sensor Contamination from oil, coolant or fuel additives Catalytic converter or exhaust problem, less common
How do you fix code P019D?
First make sure you are looking at the correct bank, then check for exhaust leaks and inspect the wiring and connector. The car can usually still be driven, but have the light checked within a reasonable time. If oil or coolant is reaching the exhaust, that must be fixed before fitting a new sensor.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P019C — O2 sensor 3 bank 2: slow response, rich to lean
- Next code: P019E — Alternative fuel tank A pressure sensor circuit fa...
Related codes
- P0100 — Mass air flow sensor: general circuit fault
- P0101 — Mass air flow sensor: range/performance
- P0102 — Mass air flow sensor: signal too low
- P0103 — Mass air flow sensor: signal too high
- P0104 — Mass air flow sensor: intermittent signal
- P0105 — Manifold/barometric pressure sensor: general circuit fault
- P0106 — Manifold/barometric pressure sensor: implausible reading
- P0107 — Manifold/barometric pressure sensor: signal too low
- P0108 — Manifold/barometric pressure sensor: signal too high
- P0109 — Manifold/barometric pressure sensor: intermittent signal
- P010A — Mass air flow sensor B: circuit fault
- P010B — Air flow sensor B: signal out of range or implausible