Skip to content
Fault code dictionary (DTC)

P01A5 — Alternative fuel rail pressure sensor signal too low

Severity: Serious Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit is reading a voltage that is too low from the alternative fuel rail pressure sensor, which points to a wire shorted to ground, a break or a faulty sensor. The real pressure may well be normal: it is the signal that is not valid.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Switching to the main fuel or refusing to use the alternative one
Rough running or hesitation on the alternative fuel
Loss of power
Hard starting or stalling

Common causes

Sensor wire shorted to ground
Corroded, wet or loose connector
Faulty rail pressure sensor
Loss of supply to the sensor
Control unit fault, which is rare

What to do

Check the sensor connector and wiring for moisture, corrosion or damaged insulation. Work on the gas system should be left to a qualified technician. You can use the main fuel in the meantime, but have the fault checked soon.

How to read code P01A5

This is a serious fault: driving behaviour may get worse or other components may be damaged if the vehicle is used without checking it.

The code P01A5 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (A5) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P01A5 mean?

Alternative fuel rail pressure sensor signal too low. The control unit is reading a voltage that is too low from the alternative fuel rail pressure sensor, which points to a wire shorted to ground, a break or a faulty sensor. The real pressure may well be normal: it is the signal that is not valid.

Can I keep driving with code P01A5 active?

With caution: limp mode possible, have it checked soon

Common causes — P01A5

Sensor wire shorted to ground Corroded, wet or loose connector Faulty rail pressure sensor Loss of supply to the sensor Control unit fault, which is rare

How do you fix code P01A5?

Check the sensor connector and wiring for moisture, corrosion or damaged insulation. Work on the gas system should be left to a qualified technician. You can use the main fuel in the meantime, but have the fault checked soon.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes