Skip to content
Fault code dictionary (DTC)

P01A6 — Alternative fuel rail pressure sensor signal too high

Severity: Serious Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit is reading a voltage that is too high from the alternative fuel rail pressure sensor, which points to a wire shorted to supply, an open circuit or a faulty sensor. The real pressure is not necessarily high: it is the signal that is not believable.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Switching to the main fuel or refusing to use the alternative one
Rough running or hesitation on the alternative fuel
Loss of power
Hard starting or stalling

Common causes

Sensor wire shorted to supply voltage
Corroded, wet or loose connector
Faulty rail pressure sensor
Broken ground connection at the sensor
Control unit fault, which is rare

What to do

Check the sensor connector, wiring and ground. If you suspect the system pressure is truly high, do not tamper with anything and have it checked immediately by a qualified technician. If there are no other signs of danger, use the main fuel and have the car checked soon.

How to read code P01A6

This is a serious fault: driving behaviour may get worse or other components may be damaged if the vehicle is used without checking it.

The code P01A6 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (A6) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P01A6 mean?

Alternative fuel rail pressure sensor signal too high. The control unit is reading a voltage that is too high from the alternative fuel rail pressure sensor, which points to a wire shorted to supply, an open circuit or a faulty sensor. The real pressure is not necessarily high: it is the signal that is not believable.

Can I keep driving with code P01A6 active?

With caution: limp mode possible, have it checked soon

Common causes — P01A6

Sensor wire shorted to supply voltage Corroded, wet or loose connector Faulty rail pressure sensor Broken ground connection at the sensor Control unit fault, which is rare

How do you fix code P01A6?

Check the sensor connector, wiring and ground. If you suspect the system pressure is truly high, do not tamper with anything and have it checked immediately by a qualified technician. If there are no other signs of danger, use the main fuel and have the car checked soon.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes