P01AC — Alt. fuel tank temperature sensor: signal too low
| Meaning | The control unit found that the electrical signal from the alternative fuel tank temperature sensor (for example LPG or CNG) is below the normal range. This usually points to a short to ground in the wiring or a failed sensor. Without a reliable temperature reading, the system cannot calculate the amount of gas accurately. |
| Family | Powertrain (P) |
Typical symptoms
Car forced to run on petrol or diesel
Hard or refused starting on gas
Wrong gas level reading
Rough running when on gas
Common causes
Failed temperature sensor
Corroded connector or water inside it
Internal fault in the gas or engine control unit (rare)
What to do
How to read code P01AC
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P01AC starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (AC) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P01AC mean?
Alt. fuel tank temperature sensor: signal too low. The control unit found that the electrical signal from the alternative fuel tank temperature sensor (for example LPG or CNG) is below the normal range. This usually points to a short to ground in the wiring or a failed sensor. Without a reliable temperature reading, the system cannot calculate the amount of gas accurately.
Can I keep driving with code P01AC active?
With caution: limp mode possible, have it checked soon
Common causes — P01AC
Chafed or pinched sensor wiring touching ground Failed temperature sensor Corroded connector or water inside it Internal fault in the gas or engine control unit (rare)
How do you fix code P01AC?
First check the connector and wiring at the tank sensor for rubbing, moisture or corrosion. You can keep driving on the normal fuel, but have the gas system checked soon, since it is working without an important reading.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P01AB — Alternative fuel tank temperature sensor performan...
- Next code: P01AD — Alt. fuel tank temperature sensor: signal too high
Related codes
- P0100 — Mass air flow sensor: general circuit fault
- P0101 — Mass air flow sensor: range/performance
- P0102 — Mass air flow sensor: signal too low
- P0103 — Mass air flow sensor: signal too high
- P0104 — Mass air flow sensor: intermittent signal
- P0105 — Manifold/barometric pressure sensor: general circuit fault
- P0106 — Manifold/barometric pressure sensor: implausible reading
- P0107 — Manifold/barometric pressure sensor: signal too low
- P0108 — Manifold/barometric pressure sensor: signal too high
- P0109 — Manifold/barometric pressure sensor: intermittent signal
- P010A — Mass air flow sensor B: circuit fault
- P010B — Air flow sensor B: signal out of range or implausible