P01B2 — Alt. fuel tank A level sensor: signal too high
| Meaning | The control unit found that the signal from the alternative fuel tank A level sensor is above the normal range. This usually means a broken wire, an unplugged connector or contact with a power supply. The gauge may always show full or not work at all. |
| Family | Powertrain (P) |
Typical symptoms
Gas gauge always at maximum or off scale
Level that does not drop with use
Sudden switch to petrol or diesel
Risk of running out of gas without warning
Common causes
Failed level sensor
Corroded terminals
Wiring touching a power supply wire
Control unit fault (rare)
What to do
How to read code P01B2
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P01B2 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (B2) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P01B2 mean?
Alt. fuel tank A level sensor: signal too high. The control unit found that the signal from the alternative fuel tank A level sensor is above the normal range. This usually means a broken wire, an unplugged connector or contact with a power supply. The gauge may always show full or not work at all.
Can I keep driving with code P01B2 active?
With caution: limp mode possible, have it checked soon
Common causes — P01B2
Broken wire or unplugged connector Failed level sensor Corroded terminals Wiring touching a power supply wire Control unit fault (rare)
How do you fix code P01B2?
Check that the sensor connector at the tank is fully seated and that the wire is not broken. Since the gauge can be misleading, count on the normal fuel as your reserve and have the system checked soon.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P01B1 — Alt. fuel tank A level sensor: signal too low
- Next code: P01B3 — Alt. fuel tank A level sensor: erratic signal
Related codes
- P0100 — Mass air flow sensor: general circuit fault
- P0101 — Mass air flow sensor: range/performance
- P0102 — Mass air flow sensor: signal too low
- P0103 — Mass air flow sensor: signal too high
- P0104 — Mass air flow sensor: intermittent signal
- P0105 — Manifold/barometric pressure sensor: general circuit fault
- P0106 — Manifold/barometric pressure sensor: implausible reading
- P0107 — Manifold/barometric pressure sensor: signal too low
- P0108 — Manifold/barometric pressure sensor: signal too high
- P0109 — Manifold/barometric pressure sensor: intermittent signal
- P010A — Mass air flow sensor B: circuit fault
- P010B — Air flow sensor B: signal out of range or implausible