P01B1 — Alt. fuel tank A level sensor: signal too low
| Meaning | The control unit found that the signal from the alternative fuel tank A level sensor is below the normal range. This usually points to a wire shorted to ground or a failed sensor. The level may show empty even with a full tank. |
| Family | Powertrain (P) |
Typical symptoms
Gas gauge at zero even with a full tank
Forced switch to normal fuel
Constant low gas warning
Gas starting not allowed
Common causes
Failed level sensor
Connector with water or corrosion
Gas control unit fault (rare)
What to do
How to read code P01B1
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P01B1 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (B1) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P01B1 mean?
Alt. fuel tank A level sensor: signal too low. The control unit found that the signal from the alternative fuel tank A level sensor is below the normal range. This usually points to a wire shorted to ground or a failed sensor. The level may show empty even with a full tank.
Can I keep driving with code P01B1 active?
With caution: limp mode possible, have it checked soon
Common causes — P01B1
Pinched or chafed wiring touching ground Failed level sensor Connector with water or corrosion Gas control unit fault (rare)
How do you fix code P01B1?
Inspect the wiring and connector of the level sensor at the tank for rubbing or moisture. You can use normal fuel in the meantime; have the gas system checked as soon as you can.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P01B0 — Alt. fuel tank A level sensor: implausible reading
- Next code: P01B2 — Alt. fuel tank A level sensor: signal too high
Related codes
- P0100 — Mass air flow sensor: general circuit fault
- P0101 — Mass air flow sensor: range/performance
- P0102 — Mass air flow sensor: signal too low
- P0103 — Mass air flow sensor: signal too high
- P0104 — Mass air flow sensor: intermittent signal
- P0105 — Manifold/barometric pressure sensor: general circuit fault
- P0106 — Manifold/barometric pressure sensor: implausible reading
- P0107 — Manifold/barometric pressure sensor: signal too low
- P0108 — Manifold/barometric pressure sensor: signal too high
- P0109 — Manifold/barometric pressure sensor: intermittent signal
- P010A — Mass air flow sensor B: circuit fault
- P010B — Air flow sensor B: signal out of range or implausible