P01B4 — Alt. fuel rail temperature sensor: circuit fault
| Meaning | The control unit found an electrical problem in the circuit of the sensor that measures the temperature of the alternative fuel (for example gas) in the fuel rail. This is a general circuit report. Without this reading, the amount of gas injected may be calculated incorrectly. |
| Family | Powertrain (P) |
Typical symptoms
Uneven running on gas
Loss of power on gas
Forced switch to normal fuel
Emissions or consumption out of the norm
Common causes
Wiring damaged by heat or rubbing
Failed temperature sensor
Control unit problem (rare)
What to do
How to read code P01B4
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P01B4 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (B4) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P01B4 mean?
Alt. fuel rail temperature sensor: circuit fault. The control unit found an electrical problem in the circuit of the sensor that measures the temperature of the alternative fuel (for example gas) in the fuel rail. This is a general circuit report. Without this reading, the amount of gas injected may be calculated incorrectly.
Can I keep driving with code P01B4 active?
With caution: limp mode possible, have it checked soon
Common causes — P01B4
Loose or corroded sensor connector Wiring damaged by heat or rubbing Failed temperature sensor Control unit problem (rare)
How do you fix code P01B4?
First check the connector and wiring of the sensor on the gas rail for heat damage or rubbing. You can use normal fuel in the meantime, but have the system checked soon.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P01B3 — Alt. fuel tank A level sensor: erratic signal
- Next code: P01B5 — Alt. fuel rail temperature sensor: implausible rea...
Related codes
- P0100 — Mass air flow sensor: general circuit fault
- P0101 — Mass air flow sensor: range/performance
- P0102 — Mass air flow sensor: signal too low
- P0103 — Mass air flow sensor: signal too high
- P0104 — Mass air flow sensor: intermittent signal
- P0105 — Manifold/barometric pressure sensor: general circuit fault
- P0106 — Manifold/barometric pressure sensor: implausible reading
- P0107 — Manifold/barometric pressure sensor: signal too low
- P0108 — Manifold/barometric pressure sensor: signal too high
- P0109 — Manifold/barometric pressure sensor: intermittent signal
- P010A — Mass air flow sensor B: circuit fault
- P010B — Air flow sensor B: signal out of range or implausible