Skip to content
Fault code dictionary (DTC)

P01B8 — Alt. fuel rail temperature sensor: erratic signal

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit is getting a signal from the alternative fuel rail temperature sensor that jumps or drops out at times. The values change faster than the temperature really could. It is usually an electrical contact that comes and goes.
FamilyPowertrain (P)

Typical symptoms

Check engine light that comes and goes
Jerky running on gas
Sudden switches to normal fuel
Occasional loss of power on gas
Fault more obvious with vibration or heat

Common causes

Loose or corroded connector
Partly broken wire or wire damaged by heat
Sensor with an intermittent fault
Moisture in the connector
Weak ground contact

What to do

With the engine off and cold, check the sensor connector and wiring, moving them gently to find any play. This fault tends to get worse, so have it checked without waiting too long.

How to read code P01B8

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P01B8 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (B8) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P01B8 mean?

Alt. fuel rail temperature sensor: erratic signal. The control unit is getting a signal from the alternative fuel rail temperature sensor that jumps or drops out at times. The values change faster than the temperature really could. It is usually an electrical contact that comes and goes.

Can I keep driving with code P01B8 active?

With caution: limp mode possible, have it checked soon

Common causes — P01B8

Loose or corroded connector Partly broken wire or wire damaged by heat Sensor with an intermittent fault Moisture in the connector Weak ground contact

How do you fix code P01B8?

With the engine off and cold, check the sensor connector and wiring, moving them gently to find any play. This fault tends to get worse, so have it checked without waiting too long.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes