P01B7 — Alt. fuel rail temperature sensor: signal too high
| Meaning | The control unit found that the signal from the alternative fuel rail temperature sensor is above the normal range. This usually means a broken wire, an unplugged connector or contact with a power supply. The gas temperature is read as extremely low or invalid. |
| Family | Powertrain (P) |
Typical symptoms
Hard starting on gas
Uneven running on gas
Forced switch to normal fuel
Reduced performance on gas
Common causes
Failed temperature sensor
Corroded terminals
Wiring touching a power supply wire
Control unit fault (rare)
What to do
How to read code P01B7
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P01B7 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (B7) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P01B7 mean?
Alt. fuel rail temperature sensor: signal too high. The control unit found that the signal from the alternative fuel rail temperature sensor is above the normal range. This usually means a broken wire, an unplugged connector or contact with a power supply. The gas temperature is read as extremely low or invalid.
Can I keep driving with code P01B7 active?
With caution: limp mode possible, have it checked soon
Common causes — P01B7
Broken wire or poorly seated connector Failed temperature sensor Corroded terminals Wiring touching a power supply wire Control unit fault (rare)
How do you fix code P01B7?
Make sure the sensor connector on the rail is fully seated and clean, then check the wire for breaks. Have the gas system checked soon and use normal fuel in the meantime.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P01B6 — Alt. fuel rail temperature sensor: signal too low
- Next code: P01B8 — Alt. fuel rail temperature sensor: erratic signal
Related codes
- P0100 — Mass air flow sensor: general circuit fault
- P0101 — Mass air flow sensor: range/performance
- P0102 — Mass air flow sensor: signal too low
- P0103 — Mass air flow sensor: signal too high
- P0104 — Mass air flow sensor: intermittent signal
- P0105 — Manifold/barometric pressure sensor: general circuit fault
- P0106 — Manifold/barometric pressure sensor: implausible reading
- P0107 — Manifold/barometric pressure sensor: signal too low
- P0108 — Manifold/barometric pressure sensor: signal too high
- P0109 — Manifold/barometric pressure sensor: intermittent signal
- P010A — Mass air flow sensor B: circuit fault
- P010B — Air flow sensor B: signal out of range or implausible