P01D4 — Cylinder 5 injection timing too advanced
| Meaning | The control unit detected that fuel injection in cylinder 5 happens earlier than the moment it commanded. The engine may keep running, but combustion in that cylinder is not occurring at the right time. The code points to a timing problem; it does not by itself say which part has failed. |
| Family | Powertrain (P) |
Typical symptoms
Rough running, especially at idle
Unusual knocking or ticking noise
Loss of power when accelerating
Smoke from the exhaust or a smell of unburnt fuel
Harder starting than normal
Common causes
Wiring or connector problem at the injector
Irregular fuel pressure in the supply system
Wrong signal from the crankshaft or camshaft sensors
Engine timing out of position
Internal control unit fault, which is rare
What to do
How to read code P01D4
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P01D4 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (D4) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P01D4 mean?
Cylinder 5 injection timing too advanced. The control unit detected that fuel injection in cylinder 5 happens earlier than the moment it commanded. The engine may keep running, but combustion in that cylinder is not occurring at the right time. The code points to a timing problem; it does not by itself say which part has failed.
Can I keep driving with code P01D4 active?
With caution: limp mode possible, have it checked soon
Common causes — P01D4
Cylinder 5 injector worn, dirty or slow to respond Wiring or connector problem at the injector Irregular fuel pressure in the supply system Wrong signal from the crankshaft or camshaft sensors Engine timing out of position Internal control unit fault, which is rare
How do you fix code P01D4?
Have the live data for the cylinder 5 injector read out, and check the wiring and connector before replacing any part. Also check the fuel pressure and the engine speed sensor signals. Don't keep driving for long with the light on and the engine running roughly, because incorrect combustion can damage the engine.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P01D3 — Cylinder 5 injection timing too late
- Next code: P01D5 — Cylinder 6 injection timing too retarded
Related codes
- P0100 — Mass air flow sensor: general circuit fault
- P0101 — Mass air flow sensor: range/performance
- P0102 — Mass air flow sensor: signal too low
- P0103 — Mass air flow sensor: signal too high
- P0104 — Mass air flow sensor: intermittent signal
- P0105 — Manifold/barometric pressure sensor: general circuit fault
- P0106 — Manifold/barometric pressure sensor: implausible reading
- P0107 — Manifold/barometric pressure sensor: signal too low
- P0108 — Manifold/barometric pressure sensor: signal too high
- P0109 — Manifold/barometric pressure sensor: intermittent signal
- P010A — Mass air flow sensor B: circuit fault
- P010B — Air flow sensor B: signal out of range or implausible