P01D5 — Cylinder 6 injection timing too retarded
| Meaning | The control unit detected that fuel injection in cylinder 6 happens later than the moment it commanded. The fuel arrives when combustion should already have started, so that cylinder performs poorly. The code reports a delay, but does not by itself identify the responsible part. |
| Family | Powertrain (P) |
Typical symptoms
Rough running or vibration
Lack of power, especially under load
Fuel consumption that seems higher
Dark smoke or fuel smell from the exhaust
Hesitation when pressing the accelerator
Common causes
Damaged or corroded injector wiring or connector
Fuel pressure too low or unstable
Wrong signal from the crankshaft or camshaft sensors
Engine timing out of position
Internal control unit fault, which is rare
What to do
How to read code P01D5
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P01D5 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (D5) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P01D5 mean?
Cylinder 6 injection timing too retarded. The control unit detected that fuel injection in cylinder 6 happens later than the moment it commanded. The fuel arrives when combustion should already have started, so that cylinder performs poorly. The code reports a delay, but does not by itself identify the responsible part.
Can I keep driving with code P01D5 active?
With caution: limp mode possible, have it checked soon
Common causes — P01D5
Cylinder 6 injector slow, dirty or worn Damaged or corroded injector wiring or connector Fuel pressure too low or unstable Wrong signal from the crankshaft or camshaft sensors Engine timing out of position Internal control unit fault, which is rare
How do you fix code P01D5?
First check the wiring and connector of the cylinder 6 injector, then the fuel pressure and the live data. Don't replace the injector without verifying how it performs. With the engine running badly it is best to have it looked at soon and to avoid heavy loads.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P01D4 — Cylinder 5 injection timing too advanced
- Next code: P01D6 — Cylinder 6 injection timing too advanced
Related codes
- P0100 — Mass air flow sensor: general circuit fault
- P0101 — Mass air flow sensor: range/performance
- P0102 — Mass air flow sensor: signal too low
- P0103 — Mass air flow sensor: signal too high
- P0104 — Mass air flow sensor: intermittent signal
- P0105 — Manifold/barometric pressure sensor: general circuit fault
- P0106 — Manifold/barometric pressure sensor: implausible reading
- P0107 — Manifold/barometric pressure sensor: signal too low
- P0108 — Manifold/barometric pressure sensor: signal too high
- P0109 — Manifold/barometric pressure sensor: intermittent signal
- P010A — Mass air flow sensor B: circuit fault
- P010B — Air flow sensor B: signal out of range or implausible