P01E7 — Coolant temperature sensor 3 intermittent signal
| Meaning | The control unit detected that the signal from the third engine coolant temperature sensor comes and goes or jumps erratically. This usually points to a contact that breaks at times. Which point of the engine this sensor monitors depends on the manufacturer, and I have no reliable information to say without the make and model. |
| Family | Powertrain (P) |
Typical symptoms
Temperature gauge that wavers or jumps
Fan starting and stopping oddly
Rough running at times
Difficult starting only some of the time
Problems that appear with vibration or damp
Common causes
Wiring with a partly broken wire, often from vibration or rubbing
Temperature sensor working intermittently
Moisture in the connector
Ground problem at the sensor or in the circuit
Internal control unit fault, which is rare
What to do
How to read code P01E7
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P01E7 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (E7) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P01E7 mean?
Coolant temperature sensor 3 intermittent signal. The control unit detected that the signal from the third engine coolant temperature sensor comes and goes or jumps erratically. This usually points to a contact that breaks at times. Which point of the engine this sensor monitors depends on the manufacturer, and I have no reliable information to say without the make and model.
Can I keep driving with code P01E7 active?
With caution: limp mode possible, have it checked soon
Common causes — P01E7
Connector with weak or corroded contact Wiring with a partly broken wire, often from vibration or rubbing Temperature sensor working intermittently Moisture in the connector Ground problem at the sensor or in the circuit Internal control unit fault, which is rare
How do you fix code P01E7?
Check the connector and wiring, gently moving the wires with the engine off to find the spot causing the trouble. Then have the live data read while the engine is running. The fault is annoying but not immediate; keep an eye on the temperature gauge until it is fixed.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P01E6 — Coolant temperature sensor 3 circuit high
- Next code: P01E8 — Coolant heater A control circuit open
Related codes
- P0100 — Mass air flow sensor: general circuit fault
- P0101 — Mass air flow sensor: range/performance
- P0102 — Mass air flow sensor: signal too low
- P0103 — Mass air flow sensor: signal too high
- P0104 — Mass air flow sensor: intermittent signal
- P0105 — Manifold/barometric pressure sensor: general circuit fault
- P0106 — Manifold/barometric pressure sensor: implausible reading
- P0107 — Manifold/barometric pressure sensor: signal too low
- P0108 — Manifold/barometric pressure sensor: signal too high
- P0109 — Manifold/barometric pressure sensor: intermittent signal
- P010A — Mass air flow sensor B: circuit fault
- P010B — Air flow sensor B: signal out of range or implausible