P01E6 — Coolant temperature sensor 3 circuit high
| Meaning | The control unit detected that the voltage from the third engine coolant temperature sensor is too high. This is normally read as a very low temperature, even with a hot engine. Which point of the engine this sensor monitors depends on the manufacturer, and I have no reliable information to say without the make and model. |
| Family | Powertrain (P) |
Typical symptoms
Temperature gauge showing cold even with a hot engine
Difficult starting, especially when hot
Rough engine running
Fuel consumption that seems higher
Cooling fan not starting when needed
Common causes
Sensor connector unplugged or corroded
Faulty temperature sensor
Supply or ground problem at the sensor
Internal control unit fault, which is rare
What to do
How to read code P01E6
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P01E6 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (E6) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P01E6 mean?
Coolant temperature sensor 3 circuit high. The control unit detected that the voltage from the third engine coolant temperature sensor is too high. This is normally read as a very low temperature, even with a hot engine. Which point of the engine this sensor monitors depends on the manufacturer, and I have no reliable information to say without the make and model.
Can I keep driving with code P01E6 active?
With caution: limp mode possible, have it checked soon
Common causes — P01E6
Sensor wire broken or disconnected Sensor connector unplugged or corroded Faulty temperature sensor Supply or ground problem at the sensor Internal control unit fault, which is rare
How do you fix code P01E6?
Check at once that the sensor connector is seated properly and the wiring is not broken. Then have the sensor and its supply tested. If the fan does not start, the engine can overheat without you seeing it: watch the gauge and avoid long trips until it is fixed.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P01E5 — Coolant temperature sensor 3 circuit low
- Next code: P01E7 — Coolant temperature sensor 3 intermittent signal
Related codes
- P0100 — Mass air flow sensor: general circuit fault
- P0101 — Mass air flow sensor: range/performance
- P0102 — Mass air flow sensor: signal too low
- P0103 — Mass air flow sensor: signal too high
- P0104 — Mass air flow sensor: intermittent signal
- P0105 — Manifold/barometric pressure sensor: general circuit fault
- P0106 — Manifold/barometric pressure sensor: implausible reading
- P0107 — Manifold/barometric pressure sensor: signal too low
- P0108 — Manifold/barometric pressure sensor: signal too high
- P0109 — Manifold/barometric pressure sensor: intermittent signal
- P010A — Mass air flow sensor B: circuit fault
- P010B — Air flow sensor B: signal out of range or implausible