P01EE — Coolant heater B control circuit high
| Meaning | The control unit detected a higher voltage than expected in the control circuit of heater "B". It can come from a wire touching the positive supply, or from a fault in the heater or its control. |
| Family | Powertrain (P) |
Typical symptoms
Heater seems always on or never on
Uneven engine warm-up
Battery draining more than usual
No obvious symptom in normal driving
Common causes
Relay stuck closed
Heater B faulty
Damaged connector or bent terminals
Internal control unit fault (uncommon)
What to do
How to read code P01EE
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P01EE starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (EE) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P01EE mean?
Coolant heater B control circuit high. The control unit detected a higher voltage than expected in the control circuit of heater "B". It can come from a wire touching the positive supply, or from a fault in the heater or its control.
Can I keep driving with code P01EE active?
With caution: limp mode possible, have it checked soon
Common causes — P01EE
Control wire touching the positive supply Relay stuck closed Heater B faulty Damaged connector or bent terminals Internal control unit fault (uncommon)
How do you fix code P01EE?
Check the relay, connector and wiring of heater B, looking for chafing or signs of overheating. If you notice a burning smell or the battery goes flat on its own, have the car checked right away.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P01ED — Coolant heater B control circuit low
- Next code: P01EF — Coolant heater B control circuit performance
Related codes
- P0100 — Mass air flow sensor: general circuit fault
- P0101 — Mass air flow sensor: range/performance
- P0102 — Mass air flow sensor: signal too low
- P0103 — Mass air flow sensor: signal too high
- P0104 — Mass air flow sensor: intermittent signal
- P0105 — Manifold/barometric pressure sensor: general circuit fault
- P0106 — Manifold/barometric pressure sensor: implausible reading
- P0107 — Manifold/barometric pressure sensor: signal too low
- P0108 — Manifold/barometric pressure sensor: signal too high
- P0109 — Manifold/barometric pressure sensor: intermittent signal
- P010A — Mass air flow sensor B: circuit fault
- P010B — Air flow sensor B: signal out of range or implausible