Skip to content
Fault code dictionary (DTC)

P01EF — Coolant heater B control circuit performance

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit commanded heater "B", but the result does not match what it expected. The circuit is not completely open, yet the heater is not working as it should: this is out-of-range operation, not a clear-cut failure.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Engine warms up more slowly than normal
Intermittent cabin heating
Different behaviour only on a cold engine
No obvious symptom in normal driving

Common causes

Heater B with altered or scaled internal resistance
Electrical contacts with excessive resistance (corrosion, loose terminals)
Low supply voltage from a weak battery or poor ground
Low coolant level, with air in the system
Relay switching erratically

What to do

First check the coolant level, the battery and the ground connections, then the connector and relay of heater B. It is not an emergency, but have it checked within a few weeks.

How to read code P01EF

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P01EF starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (EF) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P01EF mean?

Coolant heater B control circuit performance. The control unit commanded heater "B", but the result does not match what it expected. The circuit is not completely open, yet the heater is not working as it should: this is out-of-range operation, not a clear-cut failure.

Can I keep driving with code P01EF active?

With caution: limp mode possible, have it checked soon

Common causes — P01EF

Heater B with altered or scaled internal resistance Electrical contacts with excessive resistance (corrosion, loose terminals) Low supply voltage from a weak battery or poor ground Low coolant level, with air in the system Relay switching erratically

How do you fix code P01EF?

First check the coolant level, the battery and the ground connections, then the connector and relay of heater B. It is not an emergency, but have it checked within a few weeks.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes