P01F1 — O2 sensor circuit fault, bank 1 sensor 4
| Meaning | The control unit has detected a general problem in the circuit of the oxygen sensor labelled sensor 4 on bank 1. The sensor number depends on its position in the exhaust and on the manufacturer, so exactly which sensor this is must be checked on your car's wiring diagram. I have no reliable information to say more about this position. |
| Family | Powertrain (P) |
Typical symptoms
No obvious difference in driving
Slightly irregular fuel use
Possible emissions test failure
Idle sometimes unstable
Common causes
Sensor wiring damaged or burnt by exhaust heat
Aged or failed oxygen sensor
Exhaust leaks near the sensor
Faulty power or ground for the sensor heater
What to do
How to read code P01F1
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P01F1 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (F1) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P01F1 mean?
O2 sensor circuit fault, bank 1 sensor 4. The control unit has detected a general problem in the circuit of the oxygen sensor labelled sensor 4 on bank 1. The sensor number depends on its position in the exhaust and on the manufacturer, so exactly which sensor this is must be checked on your car's wiring diagram. I have no reliable information to say more about this position.
Can I keep driving with code P01F1 active?
With caution: limp mode possible, have it checked soon
Common causes — P01F1
Corroded or disconnected sensor connector Sensor wiring damaged or burnt by exhaust heat Aged or failed oxygen sensor Exhaust leaks near the sensor Faulty power or ground for the sensor heater
How do you fix code P01F1?
Have the live data of the sensor read, and check the connector and wiring, which often run close to the hot exhaust. The car can generally be used, but act soon to avoid further codes and emissions test problems.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P01F0 — Coolant temperature fell below monitoring threshol...
- Next code: P01F2 — O2 sensor circuit low voltage, bank 1 sensor 4
Related codes
- P0100 — Mass air flow sensor: general circuit fault
- P0101 — Mass air flow sensor: range/performance
- P0102 — Mass air flow sensor: signal too low
- P0103 — Mass air flow sensor: signal too high
- P0104 — Mass air flow sensor: intermittent signal
- P0105 — Manifold/barometric pressure sensor: general circuit fault
- P0106 — Manifold/barometric pressure sensor: implausible reading
- P0107 — Manifold/barometric pressure sensor: signal too low
- P0108 — Manifold/barometric pressure sensor: signal too high
- P0109 — Manifold/barometric pressure sensor: intermittent signal
- P010A — Mass air flow sensor B: circuit fault
- P010B — Air flow sensor B: signal out of range or implausible