P01F2 — O2 sensor circuit low voltage, bank 1 sensor 4
| Meaning | The control unit reads a constantly lower voltage than normal from the oxygen sensor labelled sensor 4 on bank 1. It can be a problem with the sensor or its wiring. Which sensor is sensor 4 depends on the car and must be verified on the manufacturer's diagram. |
| Family | Powertrain (P) |
Typical symptoms
No obvious change in driving
Slightly higher fuel use
Possible emissions test failure
Other mixture-related codes
Common causes
Signal wire grounded or damaged
Corroded or water-logged connector
Exhaust leak near the sensor
Mixture problem affecting the reading
What to do
How to read code P01F2
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P01F2 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (F2) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P01F2 mean?
O2 sensor circuit low voltage, bank 1 sensor 4. The control unit reads a constantly lower voltage than normal from the oxygen sensor labelled sensor 4 on bank 1. It can be a problem with the sensor or its wiring. Which sensor is sensor 4 depends on the car and must be verified on the manufacturer's diagram.
Can I keep driving with code P01F2 active?
With caution: limp mode possible, have it checked soon
Common causes — P01F2
Aged or contaminated oxygen sensor Signal wire grounded or damaged Corroded or water-logged connector Exhaust leak near the sensor Mixture problem affecting the reading
How do you fix code P01F2?
Check the sensor connector and wiring and look for exhaust leaks, then have the live data read. It is not urgent, but don't leave it for long.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P01F1 — O2 sensor circuit fault, bank 1 sensor 4
- Next code: P01F3 — O2 sensor circuit high voltage, bank 1 sensor 4
Related codes
- P0100 — Mass air flow sensor: general circuit fault
- P0101 — Mass air flow sensor: range/performance
- P0102 — Mass air flow sensor: signal too low
- P0103 — Mass air flow sensor: signal too high
- P0104 — Mass air flow sensor: intermittent signal
- P0105 — Manifold/barometric pressure sensor: general circuit fault
- P0106 — Manifold/barometric pressure sensor: implausible reading
- P0107 — Manifold/barometric pressure sensor: signal too low
- P0108 — Manifold/barometric pressure sensor: signal too high
- P0109 — Manifold/barometric pressure sensor: intermittent signal
- P010A — Mass air flow sensor B: circuit fault
- P010B — Air flow sensor B: signal out of range or implausible