P01F7 — O2 sensor signal biased/stuck rich, bank 1 sensor 4
| Meaning | The control unit sees the signal of the oxygen sensor labelled sensor 4 on bank 1 stuck or shifted toward a rich mixture, meaning too much fuel compared with air. It can be a real mixture problem or a sensor problem. Which sensor is sensor 4 must be verified on the diagram. |
| Family | Powertrain (P) |
Typical symptoms
Fuel smell from the exhaust
Dark smoke
Higher fuel use
Irregular idle
Common causes
Leaking injectors or fuel pressure too high
Very dirty air filter
Faulty wiring or connector
Other sensors distorting the mixture
What to do
How to read code P01F7
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P01F7 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (F7) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P01F7 mean?
O2 sensor signal biased/stuck rich, bank 1 sensor 4. The control unit sees the signal of the oxygen sensor labelled sensor 4 on bank 1 stuck or shifted toward a rich mixture, meaning too much fuel compared with air. It can be a real mixture problem or a sensor problem. Which sensor is sensor 4 must be verified on the diagram.
Can I keep driving with code P01F7 active?
With caution: limp mode possible, have it checked soon
Common causes — P01F7
Failed or contaminated oxygen sensor Leaking injectors or fuel pressure too high Very dirty air filter Faulty wiring or connector Other sensors distorting the mixture
How do you fix code P01F7?
Check the air filter and look for other mixture codes, then have the sensor data read. A prolonged rich mixture can ruin the catalytic converter, so act soon.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P01F6 — O2 sensor signal biased/stuck lean, bank 1 sensor...
- Next code: P01F8 — Coolant heater A driver current/temperature too hi...
Related codes
- P0100 — Mass air flow sensor: general circuit fault
- P0101 — Mass air flow sensor: range/performance
- P0102 — Mass air flow sensor: signal too low
- P0103 — Mass air flow sensor: signal too high
- P0104 — Mass air flow sensor: intermittent signal
- P0105 — Manifold/barometric pressure sensor: general circuit fault
- P0106 — Manifold/barometric pressure sensor: implausible reading
- P0107 — Manifold/barometric pressure sensor: signal too low
- P0108 — Manifold/barometric pressure sensor: signal too high
- P0109 — Manifold/barometric pressure sensor: intermittent signal
- P010A — Mass air flow sensor B: circuit fault
- P010B — Air flow sensor B: signal out of range or implausible