P01F6 — O2 sensor signal biased/stuck lean, bank 1 sensor 4
| Meaning | The control unit sees the signal of the oxygen sensor labelled sensor 4 on bank 1 stuck or shifted toward a lean mixture, meaning little fuel compared with air. It can be a real mixture problem or a sensor problem. Which sensor is sensor 4 must be verified on the diagram. |
| Family | Powertrain (P) |
Typical symptoms
Hesitation or jerking when accelerating
Irregular idle
Loss of power
Possible emissions test failure
Common causes
Aged or failed oxygen sensor
Low fuel pressure or dirty injectors
Faulty wiring or connector
Intake manifold leak
What to do
How to read code P01F6
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P01F6 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (F6) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P01F6 mean?
O2 sensor signal biased/stuck lean, bank 1 sensor 4. The control unit sees the signal of the oxygen sensor labelled sensor 4 on bank 1 stuck or shifted toward a lean mixture, meaning little fuel compared with air. It can be a real mixture problem or a sensor problem. Which sensor is sensor 4 must be verified on the diagram.
Can I keep driving with code P01F6 active?
With caution: limp mode possible, have it checked soon
Common causes — P01F6
Air leak or exhaust leak near the sensor Aged or failed oxygen sensor Low fuel pressure or dirty injectors Faulty wiring or connector Intake manifold leak
How do you fix code P01F6?
First look for air leaks in the intake and exhaust, then check the sensor data. A lean mixture for a long time can overheat the engine, so don't leave it too long.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P01F5 — O2 sensor no activity detected, bank 1 sensor 4
- Next code: P01F7 — O2 sensor signal biased/stuck rich, bank 1 sensor...
Related codes
- P0100 — Mass air flow sensor: general circuit fault
- P0101 — Mass air flow sensor: range/performance
- P0102 — Mass air flow sensor: signal too low
- P0103 — Mass air flow sensor: signal too high
- P0104 — Mass air flow sensor: intermittent signal
- P0105 — Manifold/barometric pressure sensor: general circuit fault
- P0106 — Manifold/barometric pressure sensor: implausible reading
- P0107 — Manifold/barometric pressure sensor: signal too low
- P0108 — Manifold/barometric pressure sensor: signal too high
- P0109 — Manifold/barometric pressure sensor: intermittent signal
- P010A — Mass air flow sensor B: circuit fault
- P010B — Air flow sensor B: signal out of range or implausible