P01FE — Turbo outlet pressure sensor B: unstable signal
| Meaning | The control unit saw the signal from sensor B, which measures turbo outlet pressure, drop out or jump in an implausible way. This usually points to an unreliable electrical contact rather than a clear-cut failure. Which sensor is physically 'B' differs from one manufacturer to another. |
| Family | Powertrain (P) |
Typical symptoms
Occasional loss of power
Jerking under acceleration
Problem appears with vibration or rain
Reduced-power mode that comes and goes
Common causes
Partly broken or chafed wire
Sensor with an intermittent internal fault
Leak in the charge-air pipework skewing the reading
Unstable ground or supply
What to do
How to read code P01FE
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P01FE starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (FE) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P01FE mean?
Turbo outlet pressure sensor B: unstable signal. The control unit saw the signal from sensor B, which measures turbo outlet pressure, drop out or jump in an implausible way. This usually points to an unreliable electrical contact rather than a clear-cut failure. Which sensor is physically 'B' differs from one manufacturer to another.
Can I keep driving with code P01FE active?
With caution: limp mode possible, have it checked soon
Common causes — P01FE
Connector with weak or corroded contact Partly broken or chafed wire Sensor with an intermittent internal fault Leak in the charge-air pipework skewing the reading Unstable ground or supply
How do you fix code P01FE?
Check the connector and wiring by gently moving them with the engine off, and make sure the charge-air pipes are not leaking. An intermittent fault tends to get worse, so have it looked at fairly soon.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P01FD — Turbo outlet pressure sensor B: signal too high
- Next code: P01FF — Turbo outlet pressure sensors A and B: readings di...
Related codes
- P0100 — Mass air flow sensor: general circuit fault
- P0101 — Mass air flow sensor: range/performance
- P0102 — Mass air flow sensor: signal too low
- P0103 — Mass air flow sensor: signal too high
- P0104 — Mass air flow sensor: intermittent signal
- P0105 — Manifold/barometric pressure sensor: general circuit fault
- P0106 — Manifold/barometric pressure sensor: implausible reading
- P0107 — Manifold/barometric pressure sensor: signal too low
- P0108 — Manifold/barometric pressure sensor: signal too high
- P0109 — Manifold/barometric pressure sensor: intermittent signal
- P010A — Mass air flow sensor B: circuit fault
- P010B — Air flow sensor B: signal out of range or implausible