P01FF — Turbo outlet pressure sensors A and B: readings disagree
| Meaning | The control unit compares the two sensors that measure air pressure at the turbo outlet and found that their readings do not match as they should. It does not say which one is wrong: it could be either sensor, the wiring or a real problem in the air circuit. The position of the two sensors depends on the manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Reduced power or protection mode
Turbo boosting weakly or unevenly
Whistling or unusual turbo noises
Unusual exhaust smoke
Common causes
Leak in the charge-air pipes or hoses
Faulty connector or wiring on one sensor
Failed sensor
Turbo or turbo control problem
What to do
How to read code P01FF
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P01FF starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (FF) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P01FF mean?
Turbo outlet pressure sensors A and B: readings disagree. The control unit compares the two sensors that measure air pressure at the turbo outlet and found that their readings do not match as they should. It does not say which one is wrong: it could be either sensor, the wiring or a real problem in the air circuit. The position of the two sensors depends on the manufacturer.
Can I keep driving with code P01FF active?
With caution: limp mode possible, have it checked soon
Common causes — P01FF
One of the two sensors dirty or out of range Leak in the charge-air pipes or hoses Faulty connector or wiring on one sensor Failed sensor Turbo or turbo control problem
How do you fix code P01FF?
First inspect the charge-air pipes, clamps and hoses for leaks or cracks, then the connectors of both sensors. If power has dropped, ease off and have it checked soon, because a badly managed turbo can get damaged.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P01FE — Turbo outlet pressure sensor B: unstable signal
- Next code: P0200 — Injector circuit: general electrical fault
Related codes
- P0100 — Mass air flow sensor: general circuit fault
- P0101 — Mass air flow sensor: range/performance
- P0102 — Mass air flow sensor: signal too low
- P0103 — Mass air flow sensor: signal too high
- P0104 — Mass air flow sensor: intermittent signal
- P0105 — Manifold/barometric pressure sensor: general circuit fault
- P0106 — Manifold/barometric pressure sensor: implausible reading
- P0107 — Manifold/barometric pressure sensor: signal too low
- P0108 — Manifold/barometric pressure sensor: signal too high
- P0109 — Manifold/barometric pressure sensor: intermittent signal
- P010A — Mass air flow sensor B: circuit fault
- P010B — Air flow sensor B: signal out of range or implausible