Skip to content
Fault code dictionary (DTC)

P040A — EGR temperature sensor A circuit fault

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit detected a general problem in the circuit of temperature sensor A of the EGR system, which measures how hot the gas sent back to the intake is. With an unreliable temperature reading, the unit can't properly control and check the recirculation.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Rough idle in some cases
Higher emissions
Slight loss of power
Fuel consumption higher than normal
No obvious symptoms in the early stages

Common causes

Damaged sensor wiring
Corroded or loose connector
Faulty EGR temperature sensor
Sensor fouled with soot or damaged by heat
EGR cooler or valve in poor condition
Control unit fault, which is rare

What to do

Have the sensor connector and wiring checked and the temperature value read with a diagnostic tool. It is not usually an emergency, but don't leave it long because the EGR system isn't being monitored properly.

How to read code P040A

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P040A starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (0A) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P040A mean?

EGR temperature sensor A circuit fault. The control unit detected a general problem in the circuit of temperature sensor A of the EGR system, which measures how hot the gas sent back to the intake is. With an unreliable temperature reading, the unit can't properly control and check the recirculation.

Can I keep driving with code P040A active?

With caution: limp mode possible, have it checked soon

Common causes — P040A

Damaged sensor wiring Corroded or loose connector Faulty EGR temperature sensor Sensor fouled with soot or damaged by heat EGR cooler or valve in poor condition Control unit fault, which is rare

How do you fix code P040A?

Have the sensor connector and wiring checked and the temperature value read with a diagnostic tool. It is not usually an emergency, but don't leave it long because the EGR system isn't being monitored properly.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes