Skip to content
Fault code dictionary (DTC)

P04AA — Exhaust pressure valve B position sensor signal intermittent

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit sees the signal from the valve B position sensor appear and disappear, or vary erratically for no reason. This usually points to an unstable electrical contact. The fault may show up only with vibration, heat or moisture.
FamilyPowertrain (P)

Typical symptoms

Check engine light that comes on and sometimes goes off
Occasional loss of power
Engine going into limp mode now and then
Turbo response that comes and goes
Problem appearing on rough roads or with a hot engine

Common causes

Connector with loose or corroded terminals
Wiring with a partly broken or chafed wire
Moisture or water in the connector
Position sensor starting to fail
Grounds or power supplies with poor contact

What to do

Check the connector and wiring by gently moving them, looking for frayed wires, corrosion or signs of moisture. Intermittent faults tend to get worse over time, so have it checked without letting too much time pass.

How to read code P04AA

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P04AA starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (AA) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P04AA mean?

Exhaust pressure valve B position sensor signal intermittent. The control unit sees the signal from the valve B position sensor appear and disappear, or vary erratically for no reason. This usually points to an unstable electrical contact. The fault may show up only with vibration, heat or moisture.

Can I keep driving with code P04AA active?

With caution: limp mode possible, have it checked soon

Common causes — P04AA

Connector with loose or corroded terminals Wiring with a partly broken or chafed wire Moisture or water in the connector Position sensor starting to fail Grounds or power supplies with poor contact

How do you fix code P04AA?

Check the connector and wiring by gently moving them, looking for frayed wires, corrosion or signs of moisture. Intermittent faults tend to get worse over time, so have it checked without letting too much time pass.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes