Skip to content
Fault code dictionary (DTC)

P04BB — Fuel door lock control: open circuit

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit commanded the fuel door lock and found the circuit broken, as if the actuator were unplugged. The lock may therefore not engage when it should.
FamilyPowertrain (P)

Typical symptoms

Check engine or warning light on
Fuel door stays free and does not lock
No sound from the actuator when the car is locked
Dashboard fault message related to the fuel door
Erratic refuelling behaviour

Common causes

Actuator connector unplugged or corroded
Broken wire, often from wear near the hinge or wheel arch
Lock actuator with burnt coil or motor
Blown fuse in the fuel door circuit
Control unit output stage damaged

What to do

Check the fuse and the actuator connector near the fuel door, looking for cut or corroded wires. It is not urgent for driving, but the door may stay unlocked, so have it looked at without leaving it too long.

How to read code P04BB

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P04BB starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (BB) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P04BB mean?

Fuel door lock control: open circuit. The control unit commanded the fuel door lock and found the circuit broken, as if the actuator were unplugged. The lock may therefore not engage when it should.

Can I keep driving with code P04BB active?

With caution: limp mode possible, have it checked soon

Common causes — P04BB

Actuator connector unplugged or corroded Broken wire, often from wear near the hinge or wheel arch Lock actuator with burnt coil or motor Blown fuse in the fuel door circuit Control unit output stage damaged

How do you fix code P04BB?

Check the fuse and the actuator connector near the fuel door, looking for cut or corroded wires. It is not urgent for driving, but the door may stay unlocked, so have it looked at without leaving it too long.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes