Skip to content
Fault code dictionary (DTC)

P04C2 — Fuel door unlock control: circuit high

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit saw a higher than expected voltage on the fuel door unlock control. It may be a wire touching a positive supply or a fault in the electronics driving the actuator.
FamilyPowertrain (P)

Typical symptoms

Check engine or warning light on
Fuel door unlocks by itself or no longer locks
Actuator staying powered and getting hot
Fault message on the dashboard
Door seems to open when it should not

Common causes

Unlock wire touching a positive supply
Connector with bent or touching terminals
Faulty actuator
Control unit output stuck on
Wiring repaired incorrectly

What to do

Check the actuator connector and wiring for bare wires or touching terminals. If the door unlocks by itself or the actuator heats up, have it checked soon.

How to read code P04C2

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P04C2 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (C2) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P04C2 mean?

Fuel door unlock control: circuit high. The control unit saw a higher than expected voltage on the fuel door unlock control. It may be a wire touching a positive supply or a fault in the electronics driving the actuator.

Can I keep driving with code P04C2 active?

With caution: limp mode possible, have it checked soon

Common causes — P04C2

Unlock wire touching a positive supply Connector with bent or touching terminals Faulty actuator Control unit output stuck on Wiring repaired incorrectly

How do you fix code P04C2?

Check the actuator connector and wiring for bare wires or touching terminals. If the door unlocks by itself or the actuator heats up, have it checked soon.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes