Skip to content
Fault code dictionary (DTC)

P04C7 — Fuel door lock position sensor: intermittent signal

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe fuel door lock position sensor signal comes and goes or changes for no reason. The control unit sees it as intermittent. This usually comes from a contact that opens and closes with vibration or moisture.
FamilyPowertrain (P)

Typical symptoms

Check engine or warning light coming and going
Not-locked warning that appears and disappears
Fault noticed on rough roads or after washing the car
Lock sometimes works and sometimes does not
Different dashboard messages each time

Common causes

Connector with corroded or loose contacts
Sensor wire with damaged insulation or partly broken
Sensor or microswitch with an unstable contact
Fuel door vibrating or with play
Moisture in the actuator connector

What to do

Gently move the harness near the actuator and check the connector for water or corrosion. Intermittent faults are the hardest to find, so tell the technician when it shows up.

How to read code P04C7

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P04C7 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (C7) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P04C7 mean?

Fuel door lock position sensor: intermittent signal. The fuel door lock position sensor signal comes and goes or changes for no reason. The control unit sees it as intermittent. This usually comes from a contact that opens and closes with vibration or moisture.

Can I keep driving with code P04C7 active?

With caution: limp mode possible, have it checked soon

Common causes — P04C7

Connector with corroded or loose contacts Sensor wire with damaged insulation or partly broken Sensor or microswitch with an unstable contact Fuel door vibrating or with play Moisture in the actuator connector

How do you fix code P04C7?

Gently move the harness near the actuator and check the connector for water or corrosion. Intermittent faults are the hardest to find, so tell the technician when it shows up.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes