P04EE — EVAP system: very small leak on the fuel tank side
| Meaning | The engine computer detected a very small vapor leak in the EVAP system on the fuel tank side. It is vapor only, and hard to spot by eye. This is a standard SAE/ISO code. |
| Family | Powertrain (P) |
Typical symptoms
No change in driving
Usually no smell
Failed emissions test
Light coming on after refueling
Common causes
Small crack in a vapor line
Fitting or connection not tight enough
Fuel pump seal with minimal seepage
EVAP valve with imperfect sealing
What to do
How to read code P04EE
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P04EE starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (EE) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P04EE mean?
EVAP system: very small leak on the fuel tank side. The engine computer detected a very small vapor leak in the EVAP system on the fuel tank side. It is vapor only, and hard to spot by eye. This is a standard SAE/ISO code.
Can I keep driving with code P04EE active?
With caution: limp mode possible, have it checked soon
Common causes — P04EE
Fuel cap with worn seal Small crack in a vapor line Fitting or connection not tight enough Fuel pump seal with minimal seepage EVAP valve with imperfect sealing
How do you fix code P04EE?
Check the fuel cap and its seal first: it is the most common cause. After tightening the cap properly, the light may stay on for a few drive cycles. If it doesn't go out, a smoke test is needed. It isn't urgent, but don't leave it forever.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P04ED — EVAP system: large leak on the fresh air side
- Next code: P04EF — EVAP system: very small leak on the fresh air side
Related codes
- P0400 — Exhaust Gas Recirculation Flow Malfunction
- P0401 — EGR: insufficient recirculation flow
- P0402 — EGR: excessive recirculation flow
- P0403 — EGR control circuit
- P0404 — EGR: control circuit range/performance
- P0405 — EGR sensor A circuit low
- P0406 — EGR sensor A circuit high
- P0407 — EGR sensor B circuit low
- P0408 — EGR sensor B circuit high
- P0409 — Exhaust Gas Recirculation Sensor A Circuit
- P040A — EGR temperature sensor A circuit fault
- P040B — EGR temperature sensor 1 circuit performance