Skip to content
Fault code dictionary (DTC)

P04F5 — Catalyst heater bank 2: circuit low

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe engine computer sees a lower than normal signal on the bank 2 catalyst heater circuit. This usually points to a short to ground or a failed heater. The code is standardized, but few manufacturers use it and I don't have reliable information on exact values for your brand.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Higher emissions after a cold start
Failed emissions test
No obvious change in driving
Blown circuit fuse in some cases

Common causes

Heater wire shorted to ground
Wet or corroded connector
Faulty catalyst heater
Faulty fuse or relay
Wiring damaged by exhaust heat
Engine computer fault (rare)

What to do

Check the wiring near the exhaust, the connector and the heater fuse on the bank 2 side. It isn't a safety issue, but a catalyst that doesn't heat well pollutes more at startup, so it's worth having it checked.

How to read code P04F5

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P04F5 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (F5) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P04F5 mean?

Catalyst heater bank 2: circuit low. The engine computer sees a lower than normal signal on the bank 2 catalyst heater circuit. This usually points to a short to ground or a failed heater. The code is standardized, but few manufacturers use it and I don't have reliable information on exact values for your brand.

Can I keep driving with code P04F5 active?

With caution: limp mode possible, have it checked soon

Common causes — P04F5

Heater wire shorted to ground Wet or corroded connector Faulty catalyst heater Faulty fuse or relay Wiring damaged by exhaust heat Engine computer fault (rare)

How do you fix code P04F5?

Check the wiring near the exhaust, the connector and the heater fuse on the bank 2 side. It isn't a safety issue, but a catalyst that doesn't heat well pollutes more at startup, so it's worth having it checked.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes