P080D — Upshift/skip shift solenoid circuit high
| Meaning | This code is defined by the standard, but its exact use depends on the manufacturer. The control unit detected too high a voltage in the circuit of the solenoid that commands an upshift or skip shift. It usually means an open circuit or a short to supply voltage. |
| Family | Powertrain (P) |
Typical symptoms
Missed or delayed upshifts
Transmission staying in one gear
Harsh shifts
Limp mode
Common causes
Short to supply voltage in the wiring
Corroded or poorly seated connector
Solenoid with an open coil
Faulty transmission control unit (uncommon)
What to do
How to read code P080D
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P080D starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (8) points to transmission, and the last two (0D) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P080D mean?
Upshift/skip shift solenoid circuit high. This code is defined by the standard, but its exact use depends on the manufacturer. The control unit detected too high a voltage in the circuit of the solenoid that commands an upshift or skip shift. It usually means an open circuit or a short to supply voltage.
Can I keep driving with code P080D active?
With caution: limp mode possible, have it checked soon
Common causes — P080D
Broken solenoid wire Short to supply voltage in the wiring Corroded or poorly seated connector Solenoid with an open coil Faulty transmission control unit (uncommon)
How do you fix code P080D?
Have the connector and wiring checked first, then the solenoid. If the transmission locks into a gear or enters limp mode, it's best not to keep driving for long. A diagnosis with a tool suited to your make is needed.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P080C — Upshift/skip shift solenoid circuit low
- Next code: P0810 — Clutch position control error
Related codes
- P0800 — Transfer case control system: warning light request
- P0801 — Reverse inhibit control circuit fault
- P0802 — Transmission control MIL request circuit open
- P0803 — 1-4 upshift (skip shift) solenoid control circuit fault
- P0804 — 1-4 upshift (skip shift) lamp control circuit fault
- P0805 — Clutch position sensor circuit fault
- P0806 — Clutch position sensor circuit range/performance fault
- P0807 — Clutch position sensor signal too low
- P0808 — Clutch position sensor signal too high
- P0809 — Clutch position sensor signal intermittent
- P080A — Clutch position not learned
- P080B — Upshift/skip shift solenoid circuit performance fault