P08B6 — Clutch pedal position sensor B: signal too low
| Meaning | The control unit has detected a lower than normal voltage on the circuit of clutch pedal sensor B. It generally points to a wire shorted to ground or a sensor shorted to ground. As a result the control unit cannot read the clutch position correctly. |
| Family | Powertrain (P) |
Typical symptoms
Engine that will not start or starts with difficulty
Start&Stop not working
Cruise control unavailable
Hesitation when releasing the clutch
Odd behaviour when changing gear
Common causes
Connector with moisture or dirt
Sensor shorted internally
Wiring damaged near the pedal
Sensor power supply problem
Faulty control unit (rare)
What to do
How to read code P08B6
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P08B6 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (8) points to transmission, and the last two (B6) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P08B6 mean?
Clutch pedal position sensor B: signal too low. The control unit has detected a lower than normal voltage on the circuit of clutch pedal sensor B. It generally points to a wire shorted to ground or a sensor shorted to ground. As a result the control unit cannot read the clutch position correctly.
Can I keep driving with code P08B6 active?
With caution: limp mode possible, have it checked soon
Common causes — P08B6
Signal wire pinched or chafed and touching ground Connector with moisture or dirt Sensor shorted internally Wiring damaged near the pedal Sensor power supply problem Faulty control unit (rare)
How do you fix code P08B6?
First check the wiring and connector of the sensor at the pedal, looking for chafed wires or moisture. The fault is not dangerous while driving, but it can stop the car starting. Have it checked without waiting too long.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P08B5 — Clutch pedal position sensor B: signal out of rang...
- Next code: P08B7 — Clutch pedal position sensor B: signal too high
Related codes
- P0800 — Transfer case control system: warning light request
- P0801 — Reverse inhibit control circuit fault
- P0802 — Transmission control MIL request circuit open
- P0803 — 1-4 upshift (skip shift) solenoid control circuit fault
- P0804 — 1-4 upshift (skip shift) lamp control circuit fault
- P0805 — Clutch position sensor circuit fault
- P0806 — Clutch position sensor circuit range/performance fault
- P0807 — Clutch position sensor signal too low
- P0808 — Clutch position sensor signal too high
- P0809 — Clutch position sensor signal intermittent
- P080A — Clutch position not learned
- P080B — Upshift/skip shift solenoid circuit performance fault