P08B7 — Clutch pedal position sensor B: signal too high
| Meaning | The control unit has detected a higher than normal voltage on the circuit of clutch pedal sensor B. It often means a wire touching the supply voltage, a break in the sensor's ground, or a faulty sensor. The clutch position is not being read correctly. |
| Family | Powertrain (P) |
Typical symptoms
Hard starting or no start
Start&Stop not working
Cruise control that will not engage
Hesitation when releasing the clutch
Irregular behaviour when changing gear
Common causes
Corroded connector or bent pins
Faulty sensor
Broken sensor ground
Wiring damaged near the pedal
Faulty control unit (rare)
What to do
How to read code P08B7
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P08B7 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (8) points to transmission, and the last two (B7) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P08B7 mean?
Clutch pedal position sensor B: signal too high. The control unit has detected a higher than normal voltage on the circuit of clutch pedal sensor B. It often means a wire touching the supply voltage, a break in the sensor's ground, or a faulty sensor. The clutch position is not being read correctly.
Can I keep driving with code P08B7 active?
With caution: limp mode possible, have it checked soon
Common causes — P08B7
Signal wire touching the supply voltage Corroded connector or bent pins Faulty sensor Broken sensor ground Wiring damaged near the pedal Faulty control unit (rare)
How do you fix code P08B7?
Have the connector, ground and wiring of the sensor at the pedal checked first, then the sensor. It is not a safety fault while driving, but it can stop the car starting. Best not to leave it too long.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P08B6 — Clutch pedal position sensor B: signal too low
- Next code: P08B8 — Clutch pedal position sensor B: intermittent or er...
Related codes
- P0800 — Transfer case control system: warning light request
- P0801 — Reverse inhibit control circuit fault
- P0802 — Transmission control MIL request circuit open
- P0803 — 1-4 upshift (skip shift) solenoid control circuit fault
- P0804 — 1-4 upshift (skip shift) lamp control circuit fault
- P0805 — Clutch position sensor circuit fault
- P0806 — Clutch position sensor circuit range/performance fault
- P0807 — Clutch position sensor signal too low
- P0808 — Clutch position sensor signal too high
- P0809 — Clutch position sensor signal intermittent
- P080A — Clutch position not learned
- P080B — Upshift/skip shift solenoid circuit performance fault