P08B8 — Clutch pedal position sensor B: intermittent or erratic signal
| Meaning | The control unit has seen the signal from clutch pedal sensor B drop out at times or fluctuate for no reason. The information about when you press the clutch therefore arrives in a patchy way. This can disturb starting, Start&Stop and other functions. |
| Family | Powertrain (P) |
Typical symptoms
Starting that works sometimes and not others
Start&Stop switching off at random
Cruise control disengaging by itself
Slight hesitation or jerking when changing gear
A problem that shows up with vibration
Common causes
Wire with a poor contact or partly broken near the pedal
Worn or faulty sensor
Loose sensor mounting
Power supply or ground problem in the circuit
Faulty control unit (rare)
What to do
How to read code P08B8
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P08B8 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (8) points to transmission, and the last two (B8) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P08B8 mean?
Clutch pedal position sensor B: intermittent or erratic signal. The control unit has seen the signal from clutch pedal sensor B drop out at times or fluctuate for no reason. The information about when you press the clutch therefore arrives in a patchy way. This can disturb starting, Start&Stop and other functions.
Can I keep driving with code P08B8 active?
With caution: limp mode possible, have it checked soon
Common causes — P08B8
Loose, corroded or damp connector Wire with a poor contact or partly broken near the pedal Worn or faulty sensor Loose sensor mounting Power supply or ground problem in the circuit Faulty control unit (rare)
How do you fix code P08B8?
First check the connector, mounting and wiring of the sensor at the pedal, gently moving the wires to see whether the signal drops. It is not a safety fault, but the car may fail to start when you need it. Intermittent faults tend to get worse, so do not wait.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P08B7 — Clutch pedal position sensor B: signal too high
- Next code: P08B9 — Clutch pedal position sensors A and B: signals do...
Related codes
- P0800 — Transfer case control system: warning light request
- P0801 — Reverse inhibit control circuit fault
- P0802 — Transmission control MIL request circuit open
- P0803 — 1-4 upshift (skip shift) solenoid control circuit fault
- P0804 — 1-4 upshift (skip shift) lamp control circuit fault
- P0805 — Clutch position sensor circuit fault
- P0806 — Clutch position sensor circuit range/performance fault
- P0807 — Clutch position sensor signal too low
- P0808 — Clutch position sensor signal too high
- P0809 — Clutch position sensor signal intermittent
- P080A — Clutch position not learned
- P080B — Upshift/skip shift solenoid circuit performance fault