Skip to content
Fault code dictionary (DTC)

P08C1 — Pressure control solenoid L: control circuit low

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe transmission control unit read a voltage that is too low on the control circuit of pressure solenoid "L". It usually means the wire is touching ground or the solenoid is drawing too much current. The letter "L" is generic: which solenoid it is depends on the manufacturer, so you need your brand's data to locate it.
FamilyPowertrain (P)

Typical symptoms

Check engine or transmission warning light on
Gearbox entering limp mode
Harsh or delayed shifts
Gears not engaging
Slipping under acceleration

Common causes

Solenoid wire touching ground because of damaged insulation
Solenoid with a shorted winding
Connector wet or soaked in oil
Damaged internal gearbox wiring
Faulty transmission control unit (rare)

What to do

Check the gearbox wiring and connector for chafed wires or moisture, then measure the solenoid resistance. If the gearbox is in limp mode, have the car checked without too much delay.

How to read code P08C1

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P08C1 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (8) points to transmission, and the last two (C1) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P08C1 mean?

Pressure control solenoid L: control circuit low. The transmission control unit read a voltage that is too low on the control circuit of pressure solenoid "L". It usually means the wire is touching ground or the solenoid is drawing too much current. The letter "L" is generic: which solenoid it is depends on the manufacturer, so you need your brand's data to locate it.

Can I keep driving with code P08C1 active?

With caution: limp mode possible, have it checked soon

Common causes — P08C1

Solenoid wire touching ground because of damaged insulation Solenoid with a shorted winding Connector wet or soaked in oil Damaged internal gearbox wiring Faulty transmission control unit (rare)

How do you fix code P08C1?

Check the gearbox wiring and connector for chafed wires or moisture, then measure the solenoid resistance. If the gearbox is in limp mode, have the car checked without too much delay.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes