Skip to content
Fault code dictionary (DTC)

P08C2 — Pressure control solenoid L: control circuit high

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe transmission control unit read a voltage that is too high on the control circuit of pressure solenoid "L". It usually points to a short to positive supply or a problem in the driving circuit. The letter "L" is generic and changes between manufacturers: I cannot tell you for certain which solenoid it is on your car.
FamilyPowertrain (P)

Typical symptoms

Check engine or transmission warning light on
Gearbox in limp mode
Very harsh shifts or jerking
Gear stuck or ratio not changing
Different behavior when cold and when warm

Common causes

Solenoid wire shorted to supply voltage
Damaged connector with bridged contacts
Faulty solenoid
Damaged internal gearbox wiring
Faulty transmission control unit

What to do

Have the gearbox wiring and connectors checked for damaged wires or dirty contacts, then the solenoid. With the gearbox in limp mode it is better not to keep using the car and to have it looked at soon.

How to read code P08C2

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P08C2 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (8) points to transmission, and the last two (C2) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P08C2 mean?

Pressure control solenoid L: control circuit high. The transmission control unit read a voltage that is too high on the control circuit of pressure solenoid "L". It usually points to a short to positive supply or a problem in the driving circuit. The letter "L" is generic and changes between manufacturers: I cannot tell you for certain which solenoid it is on your car.

Can I keep driving with code P08C2 active?

With caution: limp mode possible, have it checked soon

Common causes — P08C2

Solenoid wire shorted to supply voltage Damaged connector with bridged contacts Faulty solenoid Damaged internal gearbox wiring Faulty transmission control unit

How do you fix code P08C2?

Have the gearbox wiring and connectors checked for damaged wires or dirty contacts, then the solenoid. With the gearbox in limp mode it is better not to keep using the car and to have it looked at soon.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes